Is my spectrum compatible with my Kessler ______ slider?

It depends! We offer an eMotimo Stepper Motor Pod for Kessler compatible with several systems for the ST4. To ensure it will work for your setup please review the following:

1) That you have the required hardware

Note: We only sell the motor pod as a direct replacement to Kessler’s DC motor pods so if your slider does not integrate with the Kessler motorized system it will be similarly unable to accommodate the eMotimo stepper motors.

• If you already have a motorized setup from Kessler you are set. Our Stepper Motor Pod is a drop in replacement.

• If you only have a manual hand crank system, you will need to pick up a motor mounting plate from Kessler. These are specific to the type of dolly that you own.

2) Motor mounts to carriage or dolly/slider ends:

On these dolly systems, the motor can mount either on the carriage itself or on one of the dolly ends. At this point in time, if your motor mounts to the carriage itself, our Motor Pod will work for you. If your motor mounts on the end, you will need longer cabling to run the length of your dolly please pick up the correct length in our cable section.