1 - Getting Started ST4/ST4.3 – eMotimo

What you will need:

Connect your external network adapter to the I/O Port
Power the Network Adapter with the included 5V adapter, other adapters may break the network adapter
Connect the Ethernet cable to the Network Adapter
Power on the ST4/ST4.3
Go to the settings menu and set your i/o port to API/NetAdapt
Power Cycle your ST4/ST4.3
In Settings, select your Net. Adapt Config. screen
Record your Network Adapters IP Address and Port on your network - you will need this in the next step.

Download the Bitfocus Companion V3 software from their website here. You will have to make an account to download the software. We recommend downloading the Stable release.
Once downloaded install and launch the Companion App
Launch the GUI for the Companion App
Search the Connection list for eMotimo and Add a connection for each motion control head you are going to connect.
Select the connection from the list on the left side of the page to open the Connection settings. For each connection fill in the IP address of the Network Adapter that is connected to your unit and the Port. Leave the Connection protocol as TCP and select the model you are connecting.
Note: To find the IP Address of your network adapter connect it to the ST4/ST4.3. Power on your head and go to the settings menu and look for the Net. Adapt Config. screen. Write down your IP Address and Port and then leave that screen to release the Network Adapter and allow a device to connect to it
Your eMotimo head should now connect and show a Check Mark in the Connection Status when the connection is complete
Now you can select the Buttons Tab in the Companion GUI to start configuring your streamdeck