How do I power my TB3?

Power specs for the TB3

Input Voltage: 10.0-13.5 volts.
Current for the TB3 at rest (motors not energized):  0.10A to 0.32A based on back light setting
TB3 with Pan/Tilt motors powered:  0.66A
TB3 with Pan/Tilt/Aux motors powered:  1.15A
Connector:  2.1mm x 5.5mm x 12mm circular barrel connector – center positive.

Powering it from the wall – use the supplied adapter only - replacements can be found here  - https://emotimo.com/products/12-volt-ac-adapter-us-int .  Just because it fits doesn’t mean it will work ok!  If you power it with a recycled supply from your old wifi router that says 12 volts/ 450mA – you aren’t feeding the rig enough current and the motion will suffer.   If you plug it the the charger for a another manufacturer’s battery – it will likely harm the TB3.

For portable packs, there are oodles out there, but the landscape is changing all the time.  This one looks good on paper:

https://a.co/d/45R3mfo and decent reviews.

The smaller, 12 volt packs are more difficult to come by these days, but searching for 23000 battery on Amazon typically yields some good results with 12 volt outputs.