4 - Troubleshooting DJI Focus Motor

1. Check SA2.6 Firmware is up to date

To control the DJI Focus motor from your SA2.6 there are a few steps to follow to get started. First check that your SA2.6 is on the latest stable firmware version: SA2.6 Firmware - Update Instructions and Release Notes

2. Focus Physical Setup

Confirm that your focus motor is plugged into the middle port on your RS2/RS3. This is the only port that will allow you to control the motor from the SA2.6

3. Focus Motor Calibration

Make sure the dial function of your gimbal is set to the Focus motor. Use your dial control on the Gimbal to confirm that the Focus motor has stops calibrated. If you are able to spin the Focus motor in one direction indefinitely then the Focus motor does not have any stops calibrated and therefore will not yet be controllable from the SA2.6. Retry the setup instructions for calibrating your focus motor found in this article: 2 - DJI RS2/RS3 Gimbal Profile Setup

4. DJI Gimbal Firmware Version

If you have followed the above steps and are still not seeing control of the DJI Focus motor you might be on an incompatible Gimbal Firmware Version.

RS2 Version Last Tested: 01.05.00.20

RS3 Version Last Tested: 01.04.00.00