3 - Cinematic Preset - eMotimo ST4/ST4.3 and Conductor SA2.6 with Skaarhoj Bluepill

Setting Presets Position

1. Use the Joystick to frame up the Pan, Tilt and Slide axis
2. Use the Position or velocity control on the home screen to set your Focus and Zoom
3. If desired navigate to the M4 screen to set a position for this motor axis
4. Return to the preset page and press and hold a Pink preset button until it flashes green to lock in the position
5. Repeat steps 1-4 for each additional position you would like to save

Recalling Preset Position

1. Press and release any green preset button to recall the stored location
2. Pressing a different preset will interrupt the recall and start a recall to the new position
3. Pressing the Stop All M. button will halt all motors ending the recall

Adjusting Preset Timing

1. Use the Preset Nr. encoder to select the preset who's timing you want to adjust
2. Set the desired Run Time for the preset using the Run Time encoder this can range from 2.5-25.0 seconds
3. Set the desired Ramp Time for the preset using the Ramp Time encoder this can range from 1.0-12.2 seconds (This value is limited by the Run Time of the preset)
4. Once the preset timing is adjusted to the desired time recall the preset to see the new timing (Note that eMotimo devices will adjust these timing values internally to meet the physical limitations of the motors should they be exceeded by the setup)

eMotimo Notes for Video Assets:

• Shot showing how to frame a preset and save the position for two unique positions
• Shot showing how to recall a saved preset
• Shot showing how to adjust the timing of a saved preset
• Shot showing how to stop a preset recall and/or call a different preset
• Shot showing that there are 30 available presets
• Shot showing quick navigation between Presets page and live control using the joystick button/up button of Menu Nav