Setting Up a Loop
- Use the Preset Setup to set positions that will be the endpoints of your desired loops
- On the looping page use the right navigation to get to the end point setup screen
- Use the Loop Nr. encoder to select which loop you are configuring
- Use the A Point encoder to select the ID of the Preset position for the End Point A of the loop
- Use the B Point encoder to select the ID of the Preset position for the End Point B of the loop
- Press the Start/Stop Loop button to start looping between the two endpoints with the default timing
- Press and hold the Start/Stop Loop button to stop the looping mode, you can also use the Stop All M. button to stop the looping mode
(Note: End points cannot be changed while the loop is running. For the endpoints to be changed the loop will have to be stopped and restarted)
Adjusting the Loop Timing
- Use the Left Navigation to get to the Loop Timing setup screen
- Use the Loop Nr. encoder to select the loop who's timing you want to change
- Use the L.Run Time encoder to set the desired time to move from point A to B
- Use the L.Ramp Time encoder to set the desired acceleration time
- The timing can be adjusted while the Loop is running and the new timing will take affect after your eMotimo device reaches the next end point
eMotimo Notes for Video Assets:
- Show navigation from the Home screen to the Looping Page
- Show the Left/Right toggle between the Timing Setup and the End Point Setup
- Show the Timing Adjustments taking effect at the next pass
- Show how to stop the looping mode
Comments
0 comments
Please sign in to leave a comment.